Skip to content
Back to auctions

Lot photography in progress

This vehicle is on the upcoming auction block. The auction house is still processing the lot photos.

2010 Toyota Blade

Lot #10044 · Chassis GRE156H

Starting bid

≈ A$757

¥80,000 at ¥105.75 per A$1

Est. landed

~$16,767

drive-away, QLD

Auction
Wednesday 25 Nov 2026 (In 3 days)in 3 days · Wed
Grade
Auction grade 4, Good
Mileage
86,000 km
Auction house
BayaucAssessment Pending

Grade 4: minor scratches or small dents a careful owner would leave; usually under about 100,000 km. How grades work

This 2010 Toyota Blade (chassis GRE156H), graded 4.0, with 86,000 km on the clock, with a at gearbox, (3500cc engine), goes under the hammer at Bayauc on Wednesday 25 Nov 2026 (In 3 days) as lot 10044. The starting bid is ¥80,000, about A$757 at today's rate of ¥105.75 per A$1; the estimate below adds shipping, duty and GST, compliance and Queensland registration. CarStrike inspects the auction sheet, translates it and bids on your behalf up to a limit you set.

Engine
3500cc
Transmission
AT
Colour
N/A
Make
Toyota
Trim
BLADE MASTER G

Estimated landed cost

~$16,767 AUD drive-away

Car at the typical sell price (¥666,000)
$6,298
Shipping & marine insurance
$5,500
GST (10%)
$1,180
Compliance (RAV / SEVS)
$1,500
Port to yard transport
$250
Import service fee
$1,500
Registration & safety certificate
$350
Stamp duty (3%)
$189

Based on what a Toyota Blade typically sells for at the Japanese auctions — not the starting bid — at today's rate of ¥105.75 per A$1: the car in A$ at today's rate + shipping A$5,500 + GST 10% + A$3,600 on-road costs (compliance, transport, our fee, rego) + 3% stamp duty (Japanese-built cars are duty-free under JAEPA). An estimate, not a quote.

Try other prices in the import calculator

Import watchouts

  • Inspect the CVT transmission for signs of slipping or shuddering, as these units can suffer from premature wear if not serviced with the correct fluid, and manual transmissions should be checked for clutch wear due to the car’s sporty nature.
  • Check for rust around the rear wheel arches and under the rear bumper, as these areas are prone to corrosion in Australian conditions, especially if the car was exposed to road salt or coastal environments in Japan.
  • Verify the condition of the engine mounts and subframe, as these components can degrade over time, leading to excessive vibration and noise, which can be costly to replace if not addressed early.
Read the full Toyota Blade import guide

Request auction access

Tell us your limit and we bid on this lot for you.

  • Proxy bidding requirements
  • A signed bidding agreement
  • A fully refundable holding deposit (we confirm the amount with you)
  • The sheet translated and an inspection report before the hammer falls

Ask about this lot

Not ready to bid? Ask our import team anything about this car.

What a 2010 Toyota Blade sells for in Japan

From 6 Japanese auction results for 2007–2011 models (the 2010 model year). Prices in Japan are FOB: the auction price plus the Japanese-side costs to the port. Landed estimates at ¥105.75 per A$1; past results, not a quote.

Median price in Japan
¥458,000
about $4,331 at today's rate
Typical range
¥415,000 – ¥491,000
the middle half of results
Estimated landed
about $14,544
typically $14,085 – $14,897
Sold a month in Japan
about 8
at the Japanese auctions

Resale: the Blade Master holds its value better than most models in our auction data — each older model year sells for about 1.2% less.

All Toyota Blade auction prices →

Lot details come from the Japanese auction house and may change before the auction. Estimates are a guide only; CarStrike confirms the full costs before you bid.